Serial Port 3 Clock Configuration (J10) - Motorola MVME1603 Installation And Use Manual

Hardware Preparation and Installation
1

Serial Port 3 Clock Configuration (J10)

You can configure Serial port 3 on the MVME1600-001 to use the clock
signals provided by the TXC signal line. Header J10 configures port 3 to
either drive or receive TXC. The factory configuration has port 3 set to
receive TXC.
To complete the configuration of the TXC clock line, you must also set
serial port 3 clock configuration header J9 on the MVME760 transition
module, described later in this chapter. For details on the configuration of
that header, refer to the MVME760 Transition Module section or to the
user's manual for the MVME760 (part number VME760UA).
J10 J10
3 2 1 3 2 1
Receive TXC Drive TXC
(factory configuration)
1-11