Section 3. Operating Procedures; Power-Up Sequence; Power-Down Sequence - Honeywell MSU0402 Manual

Section
3
Operating Procedures
Power-
up
Sequence
In the following procedure, it is assumed that all cables have been properly con-
nected and secured and that power is supplied to the unit.
1. Open the rear door.
2. Set the MAIN POWER circuit breaker to the ON position.
3. Close the rear door.
4. A disk pack may be loaded.
Power-Down Sequence
1. Press the START/STO P button to bring the unit to a stop.
WARNING
To avoid personal injury after initiating disk unit cycle down, you must:
wait 30 seconds before lifting the disk pack access cover; then visually
verify that disk pack rotation has stopped before accessing the disk pack
area.
2. Open the cover and remove the disk pack.
3. Close the cover.
4. Open the rear door.
5. Set the MAIN POWER circuit breaker to the OFF position.
6. Close the rear door.
Operating Procedures
3-1 AT71-03