LR-60B/LS-60B Latching Crimp Heads Instructions
If making a single crimp, line up the dies within the lines on the con-
nector. If making multiple crimps on the connector, ensure there is
enough room to evenly space crimps between lug lines.
Stationary Die
Figure 3 – Aligning the Connector in the Dies
8. With hands clear of the head and other moving parts, operate the
Electrical Tool as per its instructions. After a complete cycle the ram
will retract and the tool will stop. If the ram does not retract, the crimp
is not complete and must be repeated.
9. If the ram does not fully retract, press the electrical tool pressure re-
lease button. If needed, move the head and repeat the procedure for
multiple crimps.
10. Remove the crimped connection from the head.
11. Inspect and test the connection in accordance with fitting supplier in-
structions, normal practice and applicable codes.
99 Washington Street
Melrose, MA 02176
Phone 781-665-1400
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com