Specifications - Sony STR-LV500 Operating Instructions Manual

Radio stations cannot be tuned in.
• Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
• The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use direct
tuning.
• Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning).
• No stations have been preset or the preset stations
have been cleared (when tuning by scanning
preset stations). Preset the stations (page 13).
• Press DISPLAY so that the frequency appears in
the display.
RDS does not work.
• Make sure that you're tuned to an FM RDS
station.
• Select a stronger FM station.
The RDS information that you want does not
appear.
• Contact the radio station and find out whether or
not they actually provide the service in question.
If so, the service may be temporarily out of order.
There is no picture or an unclear picture
appears on the TV screen or monitor.
• Select the appropriate input on the receiver.
• Set your TV to the appropriate input mode.
Remote control
The remote does not function.
• Point the remote at the remote sensor
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace all the batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct input on the
remote.
Reference sections for clearing
the memory
To clear
All memorized settings
GB
30

Specifications

Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, DIN)
Reference Power Output
(4 ohms 1 kHz, DIN)
1) Depending on the sound field settings and the
source, there may be no sound output.
Frequency response
Inputs (Analog)
2) INPUT SHORT.
3) Weighted network, input level.
Inputs (Digital)
DVD (Coaxial)
DVD, TV/SAT,
HDD/MD (Optical)
Sampling frequency
COAX, OPT
Outputs
LINE (sub woofer)
on the
FM tuner section
Tuning range
Antenna terminals
Intermediate frequency
Sensitivity
Mono:
Stereo:
Useable sensitivity
S/N
Mono:
Stereo:
Harmonic distortion at 1 kHz
See
Mono:
page 10
Stereo:
Separation
Frequency response
Selectivity
50 W + 50 W
1)
FRONT : 75 W + 75 W
1)
CENTER : 75 W
1)
SURROUND :
75 W + 75 W
20 Hz – 20 kHz
Sensitivity: 500 mV
Impedance: 50 kilohms
2)
S/N : 84 dB
3)
(A, 500 mV )
Impedance: 75 ohms
S/N: 90 dB
(A, 20 kHz LPF)
S/N: 90 dB
(A, 20 kHz LPF)
96 kHz
Voltage: 2 V
Impedance: 1 kilohms
87.5 - 108.0 MHz
75 ohms, unbalanced
10.7 MHz
18.3 dBf, 2.2 µV/75 ohms
38.3 dBf, 22.5 µV/75 ohms
11.2 dBf, 1 µV/75 ohms
76 dB
70 dB
0.3%
0.5%
45 dB at 1 kHz
30 Hz – 15 kHz,
+0.5/–2 dB
60 dB at 400 kHz