Eject Jam Sensor Pcb - Brother ADS-3600W Service Manual

9.12 Eject jam sensor PCB

(1) Release the paper feed / eject jam sensor harness from the securing fixtures. Release the
hook to remove the eject jam sensor PCB from the sensor holder C.
(2) Remove the two screw cup M3×6 screws, and remove the FG harness, FG spring A, and
FG spring B from the EJ pinch roller support plate.
(3) Remove the two taptite bind B M3x8 screws, and remove the EJ pinch roller support plate,
spring C, and two springs D from the front cover ASSY.
(4) Remove the taptite bind B M3x8 screw, and remove the sensor holder C from the front
cover ASSY.
Taptite bind B M3x8
Springs D
Spring C
Front cover ASSY
HARNESS ROUTING: Refer to
FG harness
FG spring A
EJ pinch roller
support plate
Paper feed jam
sensor harness
Fig. 3-38
"4. Panel unit".
3-38
Screw cup M3×6
FG spring B
Eject jam sensor PCB
Eject jam sensor
harness
Taptite bind
B M3x8
Sensor holder C
Taptite bind
B M3x8
Hook
Confidential