Chapter 4 Adjusting And Updating Settings As Required After Parts Replacement; If You Replace The Main Pcb Assy - Brother ADS-3600W Service Manual

CHAPTER 4 ADJUSTING AND UPDATING

1. IF YOU REPLACE THE MAIN PCB ASSY

<What to do after replacement>
• Installing firmware (Sub3 Firm / Main Firm)
• Adjust touch panel
• Setting by country
• Initializing the EEPROM of the main PCB ASSY
• Setting serial number
• Setting multi feeding sensor threshold
• Check sensor operation
• Check multi feeding operation
• Checking operation after repair
• Resetting to factory shipping state
 What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
(3) Service setting tool (BrUsbSn.zip)
Copy this file into the temporary folder created on the C drive.
(4) Download utility (Filedg32.exe)
Copy this file into the temporary folder created on the C drive.
(5) Maintenance driver (MaintenanceDriver.zip)
When the maintenance driver is not installed on the computer, copy this file into the
temporary folder created on the C drive, and extract the copied file. Refer to
3 INSTALLING THE MAINTENANCE PRINTER DRIVER"
(6) Firmware
Main firmware:
(E.g.) LZ5567_$.djf
Sub3 firmware:
(E.g.) LZ5613_
(7) Sheet for multi feeding sensor threshold setting (LD6340001)
(8) Multi feeding sensor threshold setting tool (brADSmt1.exe)
Copy this file into the temporary folder created on the C drive.
(9) USB flash memory
(10) Calibration sheet (LD1914001)
(11) Touch panel stylus
(12) Memory access tool (MemoryAccessTool.exe)
(13) Shipping tool (ShippingTool.exe)
(14) Scan limit sample
(15) Test chart DS-001 (LD1625001)
SETTINGS AS REQUIRED
AFTER PARTS REPLACEMENT
LZ5567 : First six digits of the part number of the firmware
$ : Alphabetic character representing the revision version of the firmware
LZ5613 : First six digits of the part number of the firmware
.djf : Firmware release year and month (YYMM)
4-1
®
XP or higher).
"APPENDIX
to install.
Confidential