Table of Contents
Advertisement
Remote Pager
This function is handy for finding the remote control if it is misplaced. Press REMOTE PAGER on the VCR, and
the remote control will beep to reveal its location.
! Turn OFF the power on the VCR.
@ Press REMOTE PAGER on the VCR.
The remote control will soon begin beeping for about 20 seconds, or until a button on the
remote control is pressed.
• The Remote Pager function operates on radio waves. The effective range of radio waves sent from the VCR is a radius of 7
meters (in a straight unobstructed line), however, this may vary depending on the surrounding environment.
• The remote control may not beep in the following situations.
- When the remote control is in a different room from the VCR.
- When the remote control is placed on a metal surface.
- When the remote control is obstructed by a large object (i.e. wall, furniture).
• After REMOTE PAGER is pressed, it may take up to five seconds before the remote control beeps.
Sharp Super Picture
This function creates clearer picture quality only during playback.
Press S. PICTURE on the VCR.
"S.PICTURE ON (or OFF)" will appear on the TV screen for a few seconds. Each time the
button is pressed, the mode switches between ON and OFF. (The Sharp Super Picture is
preset to ON at the factory.)
ON:
Normally leave the mode set to ON. This high picture quality function will create a clearer image during
playback.
OFF:
Set to OFF when playing back a tape on the VCR while editing or when strong noise appears on the screen.
• This function only operates during playback. It will not operate when recording or watching a TV program with the VCR
tuner.
• When playing S-VHS tape
1. Sharp Super Picture is set to off automatically. When finished playback, the setting will return to the previous setting.
2. You cannot change ON/OFF setting manually.
• The ON/OFF status of the Sharp Super Picture can be checked when ON SCREEN is pressed to display OSD.
• This function can not be set to ON/OFF with the MENU screen displayed. First close the MENU screen before operating this
function.
• When the VCR power is turned off, the Sharp Super Picture setting is retained in memory.
• If power is interrupted for more than 60 seconds (power failure, etc.), the setting will return to ON.
Exact Rec
When the tape is expected to run out halfway during timer recording (except for the Simple Recording Timer) in
the SP (Standard Play) mode, the mode will automatically change to the EP (Extended Play) mode to prevent
termination of recording.
Set the Exact Rec mode to ON on the SET UP-selection screen. (See Mode Selection)
About 90 minutes
About 90 minutes
SP (Standard Play) mode EP (Extended Play) mode
Total: 180 minutes
• This function may not properly work for video tapes other than T-30, T-60, T-90 and T-120.
• This tape may not be completely used up.
• When more than one program is set on the timer, the automatic recording function will work for the length of each timer-set
program, but not for the total length of all programs.
• When the EP mode is initially used for timer-recording a program, if the tape is not long enough to record the entire length of
the program, the program will not be entirely recorded.
• During a tape recorded using Exact Rec is playback, when the tape switch from SP (Standard Play) mode to
EP (Extended Play) mode, noise may appear.
For example:
• When a 180-minute program is timer-recorded with a 120-minute tape while
the automatic select is set to EP mode as shown on left.
S . P I C T U R E O N
35
Advertisement
Table of Contents
