Table of Contents
Advertisement
When the tape is expected to run out halfway during timer recording (except for the Simple Recording Timer) in
the SP (Standard Play) mode, the mode will automatically change to the LP (Long Play) mode to prevent
termination of recording.
This function works only when JUST REC mode on the MODE selection screen is set to ON.
For example:
•When a 120-minute programme is timer-recorded with a 90-minute tape while the automatic select is set to LP
mode as shown below.
|— About 60 minutes —[ j— About 30 minutes —|
SP (Standard Play) mode
LP (Long Play) mode
Total: 120 minutes
I NOTE~>
• JUST REC does not function when recording programmes in NTSC mode.
• This function may not properly work for video tapes other than E-60, E-90, E-180 and E-240.
• This tape may not be completely used up.
• When more than one programme is set on the timer, the automatic recording function will work for the length of each timer-
set programme, but not for the total length of all programmes.
• When the LP mode is initially used for timer-recording a programme, if the tape is not long enough to record the entire length
of the programme, the programme will not be entirely recorded.
• EP mode does not work with this function.
Rj Sharp Super Picture_
This function creates clearer modulation during playback for high picture quality.
Press
SUPER P.
on the VCR.
"S.PICTURE ON (or OFF)" will appear on the TV screen for a few seconds. Each
time the button is pressed, the mode switches between ON and OFF. (The Sharp
Super Picture is preset to ON at the factory.)
ON:
Normally leave the mode set to ON. This high picture quality function will create a
clearer image during playback.
OFF:
Set to OFF when playing back a tape on the VCR while editing or when strong noise
appears on the screen. Set to OFF when using the VCR as an editing source.
NOTE >
• This function only operates during playback. It will not operate when recording or watching a TV programme with the VCR
tuner.
• When playing S-VHS tape.
1. Sharp Super Picture is not function even in "S.PICTURE ON".
2. OSD Display will continuously display the previous mode.
• If power is interrupted for more than 60 minutes (power failure, etc.), the setting will return to ON.
SET
9
SUPER P.
\-
PICTURE
ON
1
28
Advertisement
Table of Contents
