Table of Contents
Advertisement
6
Press RM SET UP to finish the
Learning function process.
Tips
• When the memory capacity for storing remote
control codes reaches a certain limit, the RM SET
UP button flashes 10 times, and then the learning
process ends.
• If the RM SET UP button flashes five times in step
1, and the learning process does not start, replace
the batteries with new ones.
To cancel learning
Press RM SET UP. Also, not pressing any
button for 60 seconds cancels the settings.
Using a command that has been
learned
When selecting a learned input, press the
button used to learn that function.
To erase the learned code
1
While holding down RM SET UP, press
THEATRE.
2
Press the input button (VIDEO 1 in the
example) for which you want to clear
the setting.
The input button flashes. (The RM SET UP
button remains lit.)
3
Press ?/1 for more than 1 second.
The input button flashes twice.
4
Press SHIFT, then press numeric
buttons to clear the stored setting.
The RM SET UP button flashes twice, then
the clearing process is completed.
When the clearing process fails, the RM
SET UP button flashes five times. Try to
perform the process again from step 2.
GB
120
Clearing all the contents
of the remote's memory
MASTER
VOL –
1
Press and hold MASTER VOL –
first, then press ?/1 and then
press AV ?/1.
The RM SET UP button flashes three
times.
2
Release all buttons.
All the contents of the remote's memory
(i.e., all the programmed data) are
cleared.
AV ?/1
?/1
Advertisement
Table of Contents
