Sony 4-144-907-43(1) Operating Instructions Manual page 11

Remote commander
You can use the supplied remote commander
to operate the receiver and to control the Sony
audio/video components that the remote is
assigned to operate (page 113).
Multi function remote
commander (RM-AAL027)
Name Function
A AV ?/1 (on/
Press to turn on or off the audio/
standby) video components that the
remote is assigned to operate
(page 113).
To turn the TV on or off, press
TV (Z), then press AV ?/1.
If you press the ?/1 (B) at the
same time, it will turn off the
receiver and other Sony
components (SYSTEM
STANDBY).
Note
The function of the AV ?/1
switch changes automatically
each time you press the input
button (E).
B ?/1 (on/
Press to turn the receiver on or
standby) set it to standby mode.
If zone 2 or zone 3 is selected,
only the main receiver is turned
on or off with this button.
To turn off all Sony components
including an amplifier in zone 2
or zone 3, press ?/1 and
AV ?/1 (A) at the same time
(SYSTEM STANDBY).
To save the power in standby
mode, set "Control for HDMI"
(page 57) and "Installer Mode"
to "OFF" (page 58).
C ZONE
Press to switch the zone 2 or
zone 3 operation (page 87).
D AMP
Press to enable the receiver
operation (page 40).
E Input
Press one of the buttons to
buttons select the component you want
b)
(TV )
to use. When you press any of
the input buttons, the receiver
turns on. The buttons are
factory assigned to control Sony
components (page 51). You can
program the remote to control
non-Sony components
following the steps in
"Programming the remote"
(page 113).
SOURCE Press to output the signals for
the current input in the main
zone to zone 2 and zone 3
(page 87).
continued
GB
11