Setting The Pipe Addresses Manually - Samsung DVM S Series Installation Manual

Setting the Pipe Addresses Manually

You can use the wired or wireless remote control or the S-NET Pro 2 to set the pipe addresses for each indoor unit.
Setting by using the wired or wireless remote control (For how to operate the remote control
buttons, see the remote control user manual.)
1. Turn on both the indoor unit and the remote control.
2. Enter the "Option setting mode" on the remote control.
3. Set the address of each MCU port that is connected to an indoor unit by referring to the following table. (You can also set
the address of each indoor unit.)
Option SEG1
Value 0
Option SEG7
Value 1
Option SEG13
Value 2
Option SEG19
Value 3
Examples> If the indoor unit whose address is not yet set is connected to port A on the MCU 1, set 0A0000-100000-
20101A-300000.
If the indoor unit whose address is set to 9 is connected to port B on the MCU 2, set 0A1009-100000-20102B-300000.
Setting by using S-NET Pro 2
Set the pipe addresses by using Add-on > Change address on S-NET Pro 2. (For more information, see the S-NET Pro 2
Help.)
SEG2 SEG3
0: The address of the
indoor unit will not
be set.
A: Address setting
mode
1: The address of
the indoor unit will
be set.
SEG8 SEG9
0: The RMC address
will not be set.
0
1: The RMC address
will be set.
SEG14 SEG15
0: The MCU address
will not be set.
0
1: The MCU address
will be set.
SEG20 SEG21
0 0
SEG4 SEG5
0 to 9: Hundreds 0 to 9: Tens digit
digit of the indoor of the indoor unit
unit address address
SEG10 SEG11
0 to F: RMC group
0
channel
SEG16 SEG17
0 to 1: Tens digit of 0 to 9: Units digit of
the MCU address the MCU address
SEG22 SEG23
0 0
SEG6
0 to 9: Units digit
of the indoor unit
address
SEG12
0 to F: RMC group
address
SEG18
A to F: MCU port
address
SEG24
0
99