Black & Decker 495233-00 Instruction Manual page 16

495233-00, BDCP200 Compressor
PROBLEM
Air leak from Possible defect in safety
safety valve. valve.
Pressure reading
It is normal for "some"
on the regulated
pressure drop to occur.
pressure gauge
drops when an
accessory is
used.
Prolonged excessive use of
Compressor is not
supplying enough air.
air to operate
accessories. Compressor is not large
enough for air requirement.
Hole in hose.
Air leaks.
Excessive "auto" Condensation in tank
starting and
stopping
8/1/06 10:14 AM Page 16
CAUSE
Operate safety valve
manually by pulling on ring.
If valve still leaks, it should
be replaced.
If there is an excessive
amount of pressure drop
when the accessory is used,
adjust the regulator following
the instructions in the
"Description of Operation"
paragraph in the "Operation
Section.
NOTE: Adjust the regulated
pressure under flow
conditions (while accessory is
being used).
Decrease amount of air
usage.
Check the accessory air
requirement. If it is higher
than the SCFM or pressure
supplied by your air
compressor, you need a
larger compressor.
Check and replace if
required.
Tighten fittings.
Drain tank
16
CORRECTION