Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-16-
manual
BEFORE
Belt & Disc Sanding
To complete a typical disc sanding operation,
the operator does the following:
1.
Examines workpiece to make sure it is suit-
able for disc sanding.
2.
DISCONNECTS MACHINE FROM POWER!
3.
Adjusts table tilt as necessary and locks table
in place.
4.
Puts on safety glasses and respirator.
5.
Starts machine and dust collector. Allows
machine to reach full speed.
6.
For disc sanding, holds workpiece firmly and
flatly against both table and miter gauge
(if used), pushes workpiece into downward
spinning side of disc.
7.
For belt sanding, places workpiece on belt
sander table, then slowly, and with light pres-
sure, moves workpiece into sanding belt.
8.
When finished, stops machine and dust
collector.
Model G0864 (Mfd. Since 05/19)
Advertisement
Table of Contents
