Honeywell Experion MX Operator's Manual page 162

Table. 17.
Button/Switch Mode/Position
ON - Computer
Mode
Scan
ON – Manual Mode
ON - Computer
Mode
Off Sheet
ON – Manual Mode
CALIPER
ENABLE
OFF
RESET
X-RAY
ON
An Authorized Service Representative sets the mode of the scanner. A scanner can be in
1
either COMPUTER mode (usually for normal operation) or MANUAL mode (usually for
service). The mode change is not under Operator control.
An Authorized Service Representative sets the mode of the scanner. A scanner can be in
2
either COMPUTER mode (usually for normal operation) or MANUAL mode (usually for
service). The mode change is not under Operator control.
6510020335
Scanner Control Panel Buttons
Function
Starts scanning.
1
Starts scanning toward the motor end
support.
Closes all sensor shutters, disables sensors,
and sends the heads off-sheet at a faster
2
rate (by signaling the motor controller) and
takes the heads off line. Scanning can only
be resumed be pressing SCAN locally at the
scanner.
Starts scanning toward the cable end
support.
Sends a signal to the system to indicate that
the Caliper sensor can be enabled. This
triggers the sensor to close onto the sheet.
Disables power to the ash sensor x-ray
source
Resets the ash sensor X-ray source. It is
required that the sensor be RESET prior to
enabling power.
Enables power to the ash sensor X-ray
source (after using RESET).
PROCESS INFORMATION DISPLAYS
162