Honeywell Notifier ID3000 Series Installation & Commissioning Manual page 67

* Total system load is limited by the
available PSU output. Appendix 3, or
the Notifier Loop and Battery Calculator
Support Tool, should be used to ensure
that the system is NOT overloaded.
997-274-000-6, Issue 6
September 2009
ID3000 Series Installation & Commissioning Manual
Batteries:
Internal batteries:
Maximum battery ratings:
External batteries:
Note: With the Kit PSU3A, the maximum battery size is 38Ah
Outputs:
i) Two dedicated Sounder Outputs
ii) Two Sounder or Volt-free Contact (VFC) - selectable outputs
iii) Two VFC outputs dedicated to Common Fire and Common
Fault.
iv) Two standard, or optionally up to eight loop outputs.
v) Two 24Vdc auxiliary outputs
Sounder Output Rating
Type:
Output voltage:
Maximum load:
Fuse rating
Monitoring:
Volt-free Contact (VFC) Output Rating
Type:
Maximum load:
Fuse rating:
A2 - 4
Two 12V, 12 - 38Ah sealed, lead-acid
types MUST be used. Their lifetime
depends
temperature; refer to the battery
manufacturer's technical specification
for guidance. (Refer to PSU
specification for charger limitations).
Back Box & Battery Type Option:
Standard back box:
Extended/double extended back box:
Extended deep/double-extended deep
back box:
Externally mounted battery cabinet
Refer to the battery cabinet
documentation for battery details.
Battery lifetime depends on the
ambient temperature; refer to the
battery manufacturer's technical
specification for guidance. (Refer to
PSU specification for charger
limitations).
regardless of their location.
Voltage reversal
26 to 28V when active;
-6.8V to -9V when inactive
1A *
Electronic over-current protection
Open- and short-circuit
Single pole change-over
Contacts rated 30V 1A
Not fused
on the ambient
Yuasa
12Ah
17Ah
38Ah
130Ah