Sony RDR-GX350 Operating Instructions Manual page 92

Command Mode
Changes the Command Mode of the recorder
to avoid interference with your other Sony
DVD recorder or player.
1
Select "Command Mode" in "Options,"
and press ENTER.
2
Select a Command Mode (DVD1,
DVD2, or DVD3), and press ENTER.
b
Note
The default command mode setting for this
recorder and the supplied remote is DVD3.
The remote does not function if different
command modes are set for the recorder and
remote. Set the same command mode.
3
Set the Command Mode for the remote
so it matches the Command Mode for the
recorder you set above.
Follow the steps below to set the
Command Mode on the remote.
1 Hold down ENTER.
2 While holding down ENTER, enter
the Command Mode code number
using the number buttons.
Command Mode Code number
DVD1
DVD2
DVD3
3 Hold down both the number and
ENTER buttons at the same time for
more than three seconds.
z Hint
You can check the Command Mode for the recorder
in the front panel display.
Command
Mode
DVD1
DVD2
DVD3
92
number button 1
number button 2
number button 3
In the front panel
display
"1" appears.
"2" appears.
Either "1" or "2" does not
appear.
SMARTLINK
This Recorder Allows you to use the
Only SMARTLINK function
with the recorder when the
recorder is in standby mode.
Pass Through Allows you to use the
SMARTLINK function
with the connected
equipment when the
recorder is in standby mode.
b
Note
Set "Power Save" to "Off" in the "Basic" setup
(page 76) to set "SMARTLINK" to "Pass
Through."
DivX
Registration Code
Displays the registration code of DivX video
files for this recorder.
For more information, go to http://
www.divx.com/vod on the Internet.