Honeywell HEPAClean Series Instruction Manual page 4

ELECTRONIC FILTER CHECK REMINDER
This model air purifier has an electronic filter check to remind you when to check/replace the HEPA-Type
filters based on the air cleaner's hours of use.
When the HEPA-Type filters need to be checked, the light will remain on until it is RESET. You may unplug
the air cleaner without interrupting the filter check.
A red LED light will illuminate when it is time to check the filter.
You should periodically check the filter. Depending on operating conditions, the filters should be replaced
every 6 months.
To RESET the Electronic Filter Check:
When the filter monitor light remains on, it is time to check/replace the HEPA-Type
filters and reset the filter monitor, if needed. With the unit powered on, insert the
tip of a ball-point pen or paperclip next to the LED filter check light and hold for
approximately 5 seconds until the light turns off (Fig 5). Depending upon your
individual usage (environment and hours used), you may need to check and replace
the filters more or less frequently. If the HEPA-Type filters are replaced before the
filter monitor light turns on, the filter monitor should be reset at the same time.
These intervals are intended as guidelines only. Performance of any filter media
is dependent upon the concentration of contaminates going through the system. High concentrations of
contaminates such as dust, pet dander and smoking will reduce the useful performance of the filter.
NOTE: The HEPA-Type filters are not washable. Do not immerse in water.
REPLACING THE HEPA-TYPE FILTERS
You may be able to purchase Honeywell replacement HEPA-Type filter
where you purchased your unit or the
com. If you have any questions, contact Kaz Consumer Services at 1-800-477-0457.
MAINTAINING YOUR STAGE 1 WASHABLE PARTICLE PRE-FILTER MAINTAINING YOUR STAGE 1 WASHABLE PARTICLE PRE-FILTER
The stage 1 particle pre-filter helps pick up large airborne particles that enter
the rear grille. This pre-filter can be periodically removed and shaken to clean
it. Alternatively, it can be rinsed by hand under warm water (Fig. 6). Let the
pre-filter air dry completely before inserting back into the unit. If you need to
replace this item, please see Consumer Relations section on the next page.
4
type filters can be ordered from Kaz at www.replacementfilters.
Fig. 5
for your air purifier at the store
Fig. 6
Will illuminate
when it is
time to check
HEPA-Type
filters