Panasonic LP-GS Series Serial Communication Command Manual page 96

5. When the code type is GS1 DataBar Limited
When the code type is GS1 DataBar Limited CC-A and specify its 1D side settings
Name
(> Name in LP-400/V)
Object No.
(> Bar code No.)
System reserved
value
(Area No.)
Code type
Human readable text
Invert
and
left/right guard
pattern width to
module width ratio
Bar code height
Module width
X-position
Y-position
Rotation angle
Laser power
correction
Scan speed
correction
Pulse cycle
correction *
Total data length
* Only for LP-RF series and LP-RV series.
• With LP-400/V compatible command mode, "Code marking direction" cannot be set. To this item the setting by Laser
Marker NAVI smart or the initial value if it was not set, is applied.
• With LP-400/V compatible command mode, it is not possible to set the arbitrary value to "Left guard width to module
width ratio" and "Right guard width to module width ratio".
96
Data length
[byte]
1 "0"–"7": Object No. 1100 to 1107
1 "0"–"9", "A"–"F"
"33": GS1 DataBar Limited
2
"43": GS1 DataBar Limited CC-A
"0": OFF
1
"2": ON
Setting Invert
"0" Not invert
1
"1" Invert
"2" Invert
Model
LP-GS051(-L)
LP-GS052
7
LP-RC350S
LP-RF200P
LP-RV200P
5 "0.050"–"1.000" [mm]
8
"-999.999"–"+999.999" [mm]
8
7 "-180.00"–"+180.00" [°]
3 "000"–"999" [%]
3 "001"–"999" [%]
(3) "001"–"999" [%]
47 The data length is fixed.
or • LP-GS/LP-RC series: 47-byte
50 • LP-RF/LP-RV series: 50-byte
Data contents
Left/right guard width
to module ratio
1.0, 6.0
1.0, 6.0
3.0, 6.0
Setting range [mm]
"000.050"–"055.000"
"000.050"–"030.000"
"000.050"–"085.000"
"000.050"–"090.000"
ME-LP-GS-SR-COMP-3
Remarks
This value does not affect the settings
anymore.
For the composite codes, this setting is
applied to both 1D and 2D side.
• Set "0" to mark a bar, "1" or "2" to
mark a space.
• When the inversion is enabled,
select the left/right guard pattern
width to module width ratio.
• The readout value is always "2"
when the inversion is enabled,
regardless the settings of left/right
guard pattern.
In Laser Marker NAVI smart, this
setting is converted to the ratio of
the code height to module width and
displayed as "Bar code height to
module width ratio".
Specify a larger value than the line
width in the object group settings.
• It is the center coordinate of the
code.
• The rotation center is the center of
the code symbol.
The correction ratio is calculated using
the value set at the laser settings as
100%.