Fig. 6-7
Put the main frame on its side.
7)
Mount Torsion spring 33 (78) as
shown below.
Note: If it is reversely mounted, Spring
does not work properly.
Assemble Spark Guard (81) to Base (86) while pressing in the direction of the arrows.
9)
Spark guard
Note: To prevent melting by heated chips, Cushion (83) is not
installed at Spark guard (81) position.
Cushion (83)
Insert M6x16 H.S.Set screw (63) into Gear housing. Then adjust this Screw
8)
so that the main body can move up and down surely and fully.
Spark guard
Base
Base
Fig. 6-10
Spark guard (81)
Base (86)
Makita Corporation
Fig. 6-8
Fig. 6-9
M6x16 H.S.Set screw (63)
Spark guard
Base
12 / 15