Using The Self-Timer; Selecting A Flash Mode - Sony MVC-CD250 Operating Instructions (primary manual) Operating Instructions Manual

Using the self-timer

60min 640
4
1
, Turn the mode dial to
press V ( ) on the control
button.
The (self-timer) indicator appears on the
LCD screen.
• If the menu is currently displayed, press MENU
first so that the menu disappears.
• You can also carry out this operation when the
mode dial is set to S*, A*, M*, SCN, or
* MVC-CD400 only
2
, and , Center the subject in the frame,
and press the shutter button
fully down.
The self-timer lamp (page 11) flashes and a
beep sounds after you press the shutter
button until the shutter button is released
(approximately 10 seconds).
To cancel the self-timer in the middle
.
of the operation
Press V ( ) on the control button again.
• If you press the shutter button while standing in
front of the camera, the focus and the exposure
may not be correctly set.

Selecting a flash mode

60min
640
3
0EV
F 5 . 6
5 0
, Set the mode dial to
Each time you press v ( ), the indicator
changes as follows.
No indicator (Auto): The flash
automatically pops up and strobes when the
surroundings are dark (default).
regardless of the surrounding brightness.
60min
640
4
press v ( ) on the control
button repeatedly to select a
flash mode.
r
(Forced flash): The flash strobes
r
(No flash): The flash does not strobe.
, and
29