Configuring Dynamic Mapping Of Rdrs To Categories - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 9 Raw Data Formatting: The RDR Formatter and NetFlow Exporting

Configuring Dynamic Mapping of RDRs to Categories

Dynamic configuration of RDRs to multiple categories is supported.
Each RDR tag has a list of categories. The default category is the one that was assigned when application
was loaded.
The configuration of categories to RDR tags is done by adding and removing mappings. A user can add
a mapping of an RDR tag to a category and can remove a mapping, including the default mapping. If all
categories are removed from a tag, the tag is ignored as long as it remains with no mapped categories.
The user must provide the RDR tag ID and the category number to add or remove. The configuration is
saved as part of the application configuration.
Configuring Mappings
Use these command to add or remove a mapping.
•
•
Options
The following options are available:
•
•
From the SCE(config)# prompt, type:
Command
rdr-formatter rdr-mapping (tag-id tag-number
category-number category-number)
no rdr-formatter rdr-mapping (tag-id
tag-number category-number category-number)
How to Restore the Default Mapping for a Specified RDR Tag
From the SCE(config)# prompt, type:
Command
default rdr-formatter rdr-mapping tag-id
tag-number
OL-30621-02
Options, page 9-17
How to Restore the Default Mapping for a Specified RDR Tag, page 9-17
tag-umber—The complete 32 bit value given as an hexadecimal number. The RDR tag must be
already configured in the Formatter by the application.
category-number—Number of the category (1-4) to which to map the RDR tag.
Configuring Dynamic Mapping of RDRs to Categories
Purpose
Adds a mapping to a category. If the table already
contains a mapping with the same tag and
category number, an error is issued and nothing is
done.
Removes a mapping from a category.
Purpose
Restores the default mapping for a specified RDR
tag.
Cisco SCE 8000 10GBE Software Configuration Guide
9-17