Step 3: Connect The Power Cord; Step 4: Secure The Cords; Step 5: Turn On The Monitor And Computer - Sony SDM-E76A Operating Instructions Manual

Step 3: Connect the power cord

With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
to AC IN
to a power outlet
power cord (supplied)

Step 4: Secure the cords

Bundle the cables and cords.
Using the supplied cord strap, bundle the cables and cords.
The illustration of the back of the monitor shown here is that of
the SDM-E76D.
The same applies for the other models.
Step 5: Turn on the monitor and
Press the 1 (power) switch.
The 1 (power) indicator of the monitor lights up in green.
Turn on the computer.
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture.
If no picture appears on your screen
• Check that the power cord and the video signal cable are
properly connected.
• If NO INPUT SIGNAL appears on the screen:
The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
• If CABLE DISCONNECTED appears on the screen:
Check that the video signal cable is properly connected.
• If OUT OF RANGE appears on the screen:
Reconnect the old monitor. Then adjust the computer's
graphics board within the following ranges.
Cord strap
(supplied)
Horizontal
frequency
Vertical
frequency
Resolution
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 18.
No need for specific drivers
The monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
7
(GB)
computer
Analog RGB Digital RGB
28–80 kHz 28–64 kHz
56–75 Hz 60 Hz
1280 × 1024 or less 1280 × 1024 or less
(SDM-E76D/
SDM-E96D only)