Deleting Sub Clips; Previewing The Current Clip List; Saving The Current Clip List To Disc66 - Sony PDW-R1 Operation Manual

5-2-4 Deleting Sub Clips

KEY INHI TC COUNTER
ON SEL
NETWORK INT PRESET F-RUN
LOCAL EXT
ACCESS REMOTE
RP188 REGEN R-RUN
OFF
ALL/CH-1 CH-2 CH-3 CH-4
METER
VARIABLE
SEL
REC
PRESET
PB
AUDIO
PREV PLAY NEXT STOP
TOP F REV F FWD END
1
Carry out steps 1 to 4 of 5-2-2 "Reordering Sub Clips"
to select a sub clip and display the sub clip operation
menu.
2
Use the F or f button to select DELETE, and then
press the SET button.
The sub clip deletion screen appears.
To cancel the deletion and return to the previous
screen
Do one of the following
• Use the G or g button to select CANCEL, and then
press the SET button.
• Press the RESET button.
The screen returns to the sub clip thumbnail display.
3
Use the G or g button to select OK, and then press the
SET button.
The selected sub clip is deleted, and the screen returns
to the sub clip thumbnail display.
66
5-2 Creating Clip Lists
SET button
RESET button
SHUTTLE JOG
SUB THUMB
CLIP NAIL SHIFT
HOLD
CLIP ESSENCE
MENU
MARK
MONITOR
SEL MENU SET RESET
L/ST/R
SYSTEM S.SEL
MENU
MARK1
REC
IN OUT
MARK2
g/OUT button
F/f buttons
G/IN button
4
Save the current clip list to disc.
See 5-2-6 "Saving the Current Clip List to Disc" (page
66).
5-2-5 Previewing the Current Clip
List
Press the SUBCLIP button, turning it on, and then press
the PLAY button.
When the THUMBNAIL button is lit, playback starts from
the beginning of the selected sub clip.
When the THUMBNAIL button is not lit, playback starts
from the first sub clip in the clip list.
5-2-6 Saving the Current Clip List to
Disc
The current clip list is not saved to disc unless you carry
out this procedure. After editing clip list data, you should
always save it to disc.
Notes
• The current clip list is not saved to disc if the disc's write
protect tab is set to the recording disabled position.
• Unless you carry out this procedure, the unit does not
enter the standby state even if you set the on/standby
switch to the 1 position. Follow the message that
appears and return the on/standby switch to the & side,
and then save the clip list or, if you do not need it, clear
it (see page 69).