Connectors - Sony PDW-R1 Operation Manual

2-4 Connectors

Front
PHONES
Right side
2 DC OUT 12V connector
DC OUT 12V
S400
6
(network) connector
5
a PHONES jack and LEVEL knob
The jack is a standard stereo jack. Connect stereo
headphones with an impedance of 8 ohms, to monitor the
audio during playback. (Non-audio signals are muted.)
The channels monitored are selected by the AUDIO
MONITOR SEL button.
Adjust the volume with the LEVEL knob. When extended
menu item 820 "AUDIO OUTPUT CH1/CH2 SELECT"
is set to "moni," you can also cause this to simultaneously
adjust the output volume from the AUDIO OUT 1/3 and 2/
4 connectors on the side panel. To do this, in the setup
menu, set extended menu item 114 "AUDIO MONITOR
OUTPUT LEVEL" to "var."
1 PHONES jack and LEVEL knob
3 REMOTE connector
4 REF VIDEO IN connector
REMOTE REF VIDEO IN DIGITAL AUDIO (AES/EBU)
IN 1/2
VIDEO SDI
IN OUT1 OUT2(SUPER) IN OUT(SUPER)
4 SDI signal inputs/outputs (see page 23)
3 Analog video signal inputs/outputs (see page 23)
S400 (i.LINK) connector
2Analog audio signal inputs/
1Digital audio signal
inputs/outputs (see page
AUDIO IN
1/3
3/4 OUT 1/2 3/4
AUDIO OUT
TC
1/3
IN OUT
5Time code inputs/outputs
(see page 24)
When no headphones are connected, you can listen to
audio through the built-in speaker (monaural).
b DC OUT (DC power output) 12V connector (4-pin,
female)
Supplies power to the BVR-3 Remote Control Unit (not
supplied) and the RM-280 Editing Controller (not
supplied). (Max. 5 W)
Note
Do not connect to any external device except those listed
above.
outputs (see page 23)
DC IN
12V
2/4
AC IN
2/4
6Power supply
section (see
page 24)
2-4 Connectors
21