Black & Decker SmartCode 40490-01 Manual page 8

10. Continued.....
Programming the 3rd user code.
a. Press the program button on the interior unit three times.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the "LOCK" button to save code.
d. Press the "LOCK" button and re-enter the code to test. Unit should go
to the unlocked position allowing exterior lever to retract the latch. If it
does not go to the unlock position, repeat steps (a) through (c).
Programming the 4th user code.
a. Press the program button on the interior unit four times.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the "LOCK" button to save code.
d. Press the "LOCK" button and re-enter the code to test. Unit should go
to the unlocked position allowing exterior lever to retract the latch. If it
does not go to the unlock position, repeat steps (a) through (c).
CAUTION: Prevent unauthorized entry. This lock can be opened using four
different codes that are randomly set at the factory. Upon installation and set-up,
replace all of these codes with your own. Since anyone with access to the power
board can change these codes, you must restrict access to the power board and
routinely check both codes to assure they have not been altered without your
knowledge.
11. SmartCode User Selectable Settings.
Switch #1
5 seconds when in the ON position. Note:
The low battery RED LED cannot be
disabled.
Switch
Position
ON
OFF
Switch #2
when in the ON position. With Auto Lock en-
abled, SmartCode will automatically relock the
door 30 seconds after unlocking.
Switch #3
position. Keypad will now light red/green when buttons are pressed.
Switch #4
Hint: for easier access, use a ball point pen to operate the switches.
8
Status LED blinks every
LED
Color
Green
Orange
Red
Low Battery
Red Low Battery
Enables the AUTO LOCK
Enables the AUDIO sound (Beeper) when in the ON
Extra switch with NO FUNCTION.
Lock
Status
Unlocked
Locked
O N
1
2
3
Switches
LED
4