Table of Contents
Advertisement
2. Remove cover and battery case.
a. Remove cover from assembly
by sliding cover up and off, see
figure. 3
b. Remove the battery case from
interior assembly by lifting the
case up and out and set aside,
see figure 4.
1. Verify that position #2 of the "Settings Switch" is in the OFF posi-
tion. (Refer to section 11.)
2. Work with the door open (away from jamb) to avoid accidental
lock out.
3. Install Exterior Assembly.
Place the exterior assembly flush onto door,
threading the wire harness under the latch.
4. Install Interior Mounting plate.
Route the connector of the wire harness
though the slot at top of mounting plate.
Insert the long screws to engage exterior
assembly. Tighten screws to secure -
making sure that both the plate and the
exterior assembly are
flush against the door
and vertically aligned
with the edge of door.
Connector
Long Screws
5. Install the half round spindle.
Insert the half round spindle through the latch
fully - to engage with the exterior assembly.
Fig. 3
Important before proceeding:
Fig. 4
Harness
Mounting Plate
Half Round
Spindle
Wire
3
Hide quick links:
Advertisement
Table of Contents
