Table of Contents
Advertisement
10. Programming a User Code.
How the keypad works:
Each button represents two numbers (i.e. 1 and 2 for the first button). You
only need to push the button once to get either 1 or 2. For example: If
your code is 1-2-5-6-8,
■ Press the
■ Press the
■ Then press the
■ Then press the
■ Finally press the
● A programmed code can be from four (4) to eight (8) digits long.
● For maximum security an 8 digit code is recommended.
● Up to 4 user codes can be entered.
● Excess delay in the programming steps once started will cause unit to
beep twice and will require you to restart from step (10a).
Program
Button
Programming the 1st user code.
a. Press the program button on the interior unit once.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the "LOCK" button to save code.
d.
Press the "LOCK" button and re-enter the code to test. Unit should go
to the unlocked position allowing exterior lever to retract the latch. If it
does not go to the unlock position, repeat steps (a) through (c).
Note: Programming instructions can also be found on interior of lock.
Programming the 2nd user code.
a. Press the program button on the interior unit twice.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the "LOCK" button to save code.
Press the "LOCK" button and re-enter the code to test. Unit should go
d.
to the unlocked position allowing exterior lever to retract the latch. If it
does not go to the unlock position, repeat steps (a) through (c).
button once to get number 1.
1 2
button once to get number 2.
1 2
button once to get number 5.
5 6
button once to get number 6.
5 6
button once to get number 8.
7 8
5 6
3 4
7 8
1 2
9 0
5 6
3 4
7 8
1 2
9 0
LOCK
Button
Continued
7
Hide quick links:
Advertisement
Table of Contents
