Default Values Of Parameters With The Acs800-17Lc - ABB ACS800-17LC Hardware Manual

116
No. Name/Value
31.03 DELAY TIME
0.0 ... 3.0 s
31.04 OVERCURRENT
NO
YES
31.05 OVERVOLTAGE
NO
YES
31.06 UNDERVOLTAGE
NO
YES

Default values of parameters with the ACS800-17LC

When the IGBT Supply Control Program is loaded into the ACS800-17LC, the
following parameters receive the default values given in the table below. Do not
change the default values. If they are changed, the drive will not operate properly.
Parameter
11.01
11.02
70.01
70.19
70.20
71.01
98.01
98.02
201.09
202.01
Start-up
Description
Defines the time that the drive will wait after a fault before
attempting an automatic reset. See parameter 31.01.
Resetting delay
Activates/deactivates the automatic reset for the supply unit
overcurrent fault.
Inactive
Active
Activates/deactivates the automatic reset for the intermediate link
overvoltage fault.
Inactive
Active
Activates/deactivates the automatic reset for the intermediate link
undervoltage fault.
Inactive
Active
DC REF SELECT
Q REF SELECT
CH0 NODE ADDR
CH0 HW CONNECTION RING
CH3 HW CONNECTION RING
CH0 DRIVEBUS MODE NO
COMMAND SEL
COMM. MODULE
PANEL DRIVE ID
LOCAL LOCK
Default value
FIELDBUS
PARAM 24.02
120
MCW
INU COM LIM
2
TRUE
T./FbEq Def.
R 0 s
0 ... 300
B NO
0
65535
B NO
0
65535
B NO
0
65535