Circuit Diagram - Makita Makstar BVR340 Technical Information

R
epair
[3] -3. Flex-shaft Section (cont.)
ASSEMBLING
1) Saturate Felt ring with Lubricating oil VG46. (Refer to [2] LUBRICATION.) Assemble Felt ring to Rubber ring.
Note: Replace the rings with new ones if they are damaged.
2) Assemble Unbalancer section. (Refer to Figs. 13, 12, 11.)
3) Apply Threebond 1303 to the whole threaded portion of Cap. Fasten Cap securely to Pipe 25. (Refer to Fig. 9.)
Important: Be careful not to apply the bond to Cap other than the threaded portion.
4) Insert Unbalancer section into Pipe 25 all the way until it stops (Fig. 14). Adjust the position of Rubber ring so that
the end surface of Rubber ring is flush with that of the opening of Pipe 25 (Fig. 15).
5) Fasten Flexible hose securely to Pipe 25 while inserting Rubber ring into place. (Refer to Fig. 8.)
Important: Be careful not to tilt Rubber ring.
Fig. 14
Pipe 25
C
ircuit diagram
Color index of lead wires
Black
White
Red
Unbalancer section
Switch
Fig. 15
Rubber ring
Joint
Terminal
end surface of the opening of Pipe 25
end surface of Rubber ring
red mark
DC Motor
P 5/ 6