Makita 2702 Technical Information page 3

Assembling the frame to the motor
1. Set the flat washer 12(2 pieces) on the screw bar, and assemble the bevel gear mounted with the spring pin on
the gear housing.
2. Insert the guide bar into the gear housing.
3. Set the above parts on the frame while using care on the points shown below.
4. First assemble the guide bar at screw bar mounting side using the guide bar retainer.
5. Next assemble the guide bar at stay mounting side using the guide bar retainer.
6. At last assemble the screw bar using the screw bar retainer.
Note) The stay should pass through
the hole for the frame.
(The stay can be assembled later.)
Frame
Guide bar
Note) Set in a way that the two flat washers hold
the screw bar mounting points on the frame.
Set the motor on the position where the screw
for mounting the screw bar retainer can be fastened.
Note) Place the gear housing plate
under the guide plate.
Screw bar
Bevel gear
Flat washer