Makita 2702 Technical Information page 2

R
epair
Greasing
Before assembling, grease the MAKITA grease on the turntable and moving faces shown below.
Movable points on the frame
Frame - moving face between slide sheets
Frame retainer - Moving face between leaf springs
Up/down guide shaft, up/down screws, teeth for up/down on the motor(saw)
Teeth for tilting on the motor(saw)
Elongation hole window on the plate(steel plate for fixing inclination)(both front/back sides)
Disassembling of motor and frame
Before disassembling, disconnect the saw cutter and safety cover.
1. Turn the machine upside down and place the motor(saw) with inclined 45..
2. Shift the motor to the position where the screws for mounting the screw bar retainer can be loosened.(See (i)
on the below figure.)
3. Pull out the spring pin mounting the bevel gear for up/down in the direction shown on the figure to take away
the bevel gear.(See the (ii) on the below figure.)
4. Disconnect the screws mounting the guide retainer and screw bar retainer.
Bevel gear
Guide bar retainer
(i)
(ii)
Screw bar retainer