Cisco 3640 Series Manual page 2

Cisco 3640 Series Router-PBX Interoperability: VIC 2BRI-NT/TE card to Alcatel 4400 PBX with BRI ISDN QSIG Signaling
Set Up
This section includes the following information:
•
•
Connectivity Diagrams
Figure 1: Test Configuration
PBX1: Alcatel 4400,
slot3
Phone A
x3001
PBX #1
Phone B
x3002
Figure 1 represents the configuration used for testing: an Alcatel 4400PBX connected to a Cisco 3640
series router through an E1-QSIG connection.
Set Up Notes
The Cisco 3640 router with ISDN switch type setting of basic-qsig supports both protocol sides by using
the isdn protocol-emulate network/user command.
•
The Alcatel 4400 supports both "USER" (slave) and "NETWORK" (master) protocol sides.
•
The following options are of particular interest:
•
•
•
•
The Alcatel 4400 PBX configuration screen for the BRI trunk interface is reached using both Alcatel Board
and Board\Digital Access menus, setting the BRI physical layer parameters.
Connectivity Diagrams
Set Up Notes
Basic Call Setup End-to-End Configuration
ISDN Type:
E1-QSIG
7206VXR_A
Phone E
x N/A
Trunk interface type must be set to BRA2.
Network/User options are set in the Board/Digital Access Options menu. Network mode must be
set to Yes for Master/Network or No for Slave/User.
Access Type must be set to T0.
Q931 signal variant is used to determine Protocol type. This option was set to ISDN ABC-F.
ISDN Type:
E1-QSIG
7206VXR_B
VoIP
Phone F
x N/A
PBX2: Alcatel 4400,
slot 4
Phone C
x3000
PBX #2
Phone D
x3003
Page 2