Cisco X2-10GB-SR Installation Notes page 15

If you are cabling an optical X2 transceiver module, follow these sub-steps. If you are cabling a CX4 X2
Step 9
transceiver module, go to step 10.
a. Remove the dust plugs from the optical network interface cable SC connectors. Save the dust plugs
for future use.
b. Inspect and clean the SC connector's fiber-optic end faces.
For complete information on inspecting and cleaning fiber-optic connections, refer to the Inspection
and Cleaning Procedures for Fiber-Optic Connections document at this URL:
http://www.cisco.com/en/US/tech/tk482/tk876/technologies_white_paper09186a0080254eba.shtml
c. Remove the dust plugs from the X2 transceiver module optical bores.
d. Immediately attach the network interface cable SC connectors to the X2 transceiver module. (See
Figure
Figure 4
SC connector
Network interface
cable
Plug the InfiniBand cable connector into the CX4 X2 transceiver module connector. (See
Step 10
Make sure that the InfiniBand cable connector is aligned with the X2 transceiver module.
Figure 5
CAB-INF-28G-5
OL-23589-01
4.)
Cabling an Optical 10-Gigabit Ethernet X2 Transceiver Module
X2 transceiver
Cabling a CX4 (Copper) 10-Gigabit Ethernet X2 Transceiver Module
X2 transceiver
4X InfiniBand
connector
Cisco 10-Gigabit Ethernet X2 Transceiver Modules Installation Note
Installing the 10-Gigabit Ethernet X2 Transceiver Module
Figure 5.)
15