Table of Contents
Advertisement
Telephone Helpline: 0845 146 2887
Disconnecting a gas cylinder
•
Except for twin-cylinder installations with a
changeover valve, turn off the gas tap if fitted
to the appliance. Wait until the burner and pilot
light have gone out. For installations with a
changeover valve, it is only necessary to switch
off the empty cylinder.
•
Replace the orange safety cap onto the empty
cylinder.
Operation
Seasoning the cooking surfaces
before first use
•
Make sure the cooking surfaces are clean.
•
Apply a generous amount of oil to the plates
and some oil to the cooking grids.
•
Turn on all 6 knobs to the high position "
•
Wait 5 minutes, switch off and carefully wipe
any excess oil from the plates and grids.
Preparation before cooking
•
Wipe clean the cooking grid and griddle top.
Let dry thoroughly.
•
To prevent foods from sticking to the cooking
surface, apply a light coat of cooking/vegetable
oil before each barbecuing session.
•
Do not face directly over the gas grill when
lighting.
Note: When cooking for the first
time, cooking surfaces colour
may change slightly. This is
normal and does no indicate any
defect.
Lighting the gas grill
1. Ensure all control switches of the gas grill are
at OFF position.
2. Open the gas control valve on the gas cylinder
or regulator.
3. Press down one control switch (Fig. 4A) and
hold for 3-5 seconds to allow gas flow, then
turn anticlockwise to HI position (Fig. 4B).
CP240_UK_A5_v2_170717.indb 7
4
4. You will hear a "snap" from the igniter and see
an orange flame coming from the burner lighting
tube at the left side of the burner (Fig. 4D).
5. Continue to hold the control switch for 2
seconds after the "snap". This allows gas to
flow completely down the burner tube and
ensures ignition (Fig. 4E).
".
4
6. Ignite the remaining burners the same way.
Manual ignition
Should automatic ignition fails,
1. Remove the cooking grids and flame tamers.
2. Turn the switch anticlockwise to HI position
(Fig. 5).
5
3. Light with BBQ lighter at the distance of 5mm
to the burner fire hole.
4. Replace the cooking grids and flame tamers,
ensure to wear heat-resistant gloves.
UK
7
2017/7/17 10:40
Advertisement
Table of Contents
