Telephone Helpline: 0845 146 2887 Safety tips • Read all instructions before use and retain for future reference. • Follow all warning notices on the appliance. • Never allow children to operate this appliance. • For outdoor use only. • Position on a flat, stable surface. •...
Page 3
Telephone Helpline: 0845 146 2887 • The appliance must not have any overhead obstruction, e.g. trees, shrubs, lean-to roofs. Ensure a clearance of at least 1m around the appliance for ample ventilation. • Do not store or use gasoline or Methylated Fuels or any other flammable vapours and liquids in the vicinity of this or any other appliance.
Page 4
Telephone Helpline: 0845 146 2887 Gas, regulator and hose • For use with LPG bottled gas only. A suitable regulator must be used for butane, propane or mixes. • LP gas cylinders should rest on a stable, flat surface. • Do not place the gas bottle directly underneath the barbecue. •...
Please take a few minutes to carefully read through this manual. Correct maintenance and operation of this appliance will provide the best possible performance from your BUFFALO product. • BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. •...
Telephone Helpline: 0845 146 2887 Connecting the gas hose to the grill the arrow is pointing to the gap in the shroud. 3. Remove the orange safety cap by pulling the and the regulator lanyard out. Do not use any tools. Leave the cap hanging.
Telephone Helpline: 0845 146 2887 Disconnecting a gas cylinder • Except for twin-cylinder installations with a changeover valve, turn off the gas tap if fitted to the appliance. Wait until the burner and pilot light have gone out. For installations with a changeover valve, it is only necessary to switch off the empty cylinder.
Telephone Helpline: 0845 146 2887 Caution! • If the lighting still fails, turn the control switch to OFF. Wait 2 minutes for the unburnt gas to evaporate. Afterwards, re-light. • For any difficulty with lighting, please consult your dealer. Start cooking 1.
Telephone Helpline: 0845 146 2887 Fat fires • After each cooking session, empty and clean the oil cup of food debris. If the barbecue is to be used for large gatherings, it will be necessary to turn off and cool the barbecue every 2 hours to remove food debris from the grease cup and clean it out.
Telephone Helpline: 0845 146 2887 Cooking surfaces and all grease-collecting containers • After cooling down, remove any fat or food particles with a plastic or wooden scraper. Do not use a steel scraper or wire brush. • Clean with hot soapy water. Rinse well and dry thoroughly. •...
Page 11
Telephone Helpline: 0845 146 2887 Fault Probable Cause Solution Burner will not light Gas issues using ignitor Trying to light wrong burner Lighting the gas grill Burner not engaged with Make sure valve are positioned inside of burner control valve tubes Obstruction in burner Ensure burner tubes are not obstructed with...
BUFFALO. Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to change specifications without notice.
Telephone Helpline: 0845 146 2887 Assembly instructions Assembling tools needed (not supplied) Caution! Whilst every care is taken in the manufacture of this product, care must be taken during assembly in case sharp edges are present. Parts list Legs (x 2) Side shelf support (x 2) Bottom shelf (x 1) Side shelf (x 2)
Telephone Helpline: 0845 146 2887 Assembly steps Step 1: Assemble the bottom shelf (2) to the legs (1) using 4 bolts M6*50 (A). Step 2: Assemble both of the long fence rails (3) to the legs using 8 bolts M6*12 (B). Step 3: Assemble the threaded casters (4) to legs by twisting clockwise until...
Page 17
Telephone Helpline: 0845 146 2887 Step 4: When installing this part two people are recommended Align and place the body (5) on the legs. Attach the left and right triangular brackets (7, 6) to the rear of body and legs. Secure with 10 bolts M6*12 (B).
Page 18
Telephone Helpline: 0845 146 2887 Step 7: Attach the side shelf supports (11) to the lower connecting slices. Secure with 4 pin rolls (D) and 4 cotter pins (E). Step 8: Attach the side shelves (12) to the upper connecting slices. Secure with 4 pin rolls (D) and 4 cotter pins (E).
Page 19
Telephone Helpline: 0845 146 2887 Step 10: Place the cooking grids (14) into body. Step 11: Place the wind deflector (15) on the body. Insert the 4 pins on the wind deflector bottom into the top holes on the body. Step 12: Place the griddle top (16) on the body.
Page 20
Telephone Helpline: 0845 146 2887 Step 13: Mount the handle (18) on the drip tray (17) using 2 bolts M6*12 (B). Push the drip tray (17) into the left side of the body. Step 14: Slide the oil cup (19) into the slot underneath the drip tray (17).
Buffalo manufacturer: Fourthway Avonmouth BS11 8TB United Kingdom Product identification: Buffalo 6 Burner BBQ Griddle / Grill Combination CP240 THE PRODUCTS MENTIONED IN THIS DECLARATION ARE IN CONFORMITY WITH: EU Community Legislation Gas Appliances Directive (GAD) 2009/142/EC Harmonised standards EN 498:2012...