RIDGID GP80150RT Operator's Manual page 9

ASSEMBLY
LOOSE PARTS LIST
See Figure 1, page 23.
The following items are included with the air compressor:
Key
No. Description
1 Axle Bolt ..............................................................2
2 Spacers ...............................................................2
3 Lock Washer (18 mm) ..........................................2
4 Flat Washer (18 mm) ............................................2
5 Wheel ...................................................................2
6 Legs with Rubber Feet ........................................2
7 Nut (5 mm) ...........................................................4
8 Flat Washer (5 mm) ..............................................4
9 Lock Washer (5 mm) ............................................4
10 Screw ...................................................................4
11 Spark Plug Wrench ..............................................1
Pump Lubricant (not shown) ...............................1
Engine Lubricant (not shown) ..............................1
Operator's Manual (not shown) ...........................1
TOOLS NEEDED
The following tools (not included) are needed for assembling
or maintaining the air compressor.
 Hex Keys
 Adjustable Wrench
NOTE: Do not put fuel or oil in the air compressor before
installing the legs and wheels.
INSTALLING LEGS
See Figure 2, page 24.
 Locate the following items:
2 legs with rubber feet
4 lock washers (5 mm)
4 flat washers (5 mm)
4 nuts (5 mm)
4 screws
 Raise the front end of the air compressor, where the pump
is located, high enough to gain access to the frame bot-
tom; securely position props underneath to support.
 Position a leg over the holes on each side of the frame.
 Insert each screw through a lock washer and a flat washer,
Qty.
then insert the screws through the two holes in the leg
and the frame.
 Install a nut over each screw on the inside of the frame
and tighten securely.
 Repeat with remaining leg.
INSTALLING THE WHEELS
See Figure 3, page 24.
 Locate the following items:
2 axle bolts
2 spacers
2 lock washers (18 mm)
2 flat washers (18 mm)
2 wheels
 Raise the back end of the air compressor, where the
engine is located, high enough to gain access to the frame
bottom; securely position props underneath to support.
 Insert a wheel spacer into the center of the wheel.
 Insert axle bolt through lock washer and flat washer,
through the spacer and wheel, and then into threaded
opening on air compressor frame. Tighten axle bolt
securely.
 Repeat the process on the other side to install second
wheel.
REMOVING THE PUMP OIL LABEL
See Figure 4, page 24.
The air compressor has a label installed between the pump
oil cap and the oil fill hole. Before using the unit the first time,
remove the pump oil cap and label, then reinstall the cap.
Make sure to add oil before first use. See Adding/Checking
Pump Oil before first time operation.
9 – English