To Adjust The Tint Of Specified Colors For Twin-Color Or Single-Color Copying - Toshiba e-Studio6506AC Imaging Manual

2.16.3 To Adjust the Tint of Specified Colors for Twin-Color or Single-Color
Copying
 Explanation
In twin-color or single-color copying, the tint of the color specified from the control panel can be changed by
adjusting the toner amount of the color (Y, M, C or K).
 Procedures
*The service technician must perform all adjustments.
(1) Select [05 ADJUSTMENT MODE]. Change the values of codes [7644] to [7653] to adjust the value of Y, M,
C or K for the tint of the specified color.
(2) After changing the setting value, reboot the equipment, and check the tint of the image printed in twin-color
or single-color copying.
* Select the subcode (0 to 3) depending on which toner color (Y, M, C and K) you want to change.
* When the subcode for the specified color (Y, M, C or K) is larger, the toner amount for the adjusted color
increases, when the former is smaller, the latter decreases.
* If the value is too large, the density becomes too dark and the reproducibility of gradations in the high-
density area may become blurred and degraded. Therefore, carefully perform the adjustment, while
checking the copy or print image.
* When all the subcodes are set to "0", the specified color becomes white.
* Adjustments for yellow green, pink, orange and purple are enabled in mono color copying only.
Specified color Color of toner
from the control amount to be
panel adjusted
Magenta
Yellow
Yellow green
Cyan
Pink
e-STUDIO5506AC/6506AC/7506AC (Ver01)
[05] code
Y
M
7644
C
K
Y
M
7645
C
K
Y
M
7646
C
K
Y
M
7647
C
K
Y
7648
M
2-71
2. Copier-specific Adjustments
Acceptable
Subcode
value range
0
1
0 to 255
2
3
0
1
0 to 255
2
3
0
1
0 to 255
2
3
0
1
0 to 255
2
3
0
0 to 255
1
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
Default
128
128
128
128
128