Brady BradyPrinter S3000 User Manual page 15

Setup
Install or Change Supplies
2. Release the latch on the print head door [2] and swing open.
2
3. Swing yellow supply wiper [3] to the back, if engaged.
4. Slide yellow supply guides [4] to full-open.
5. Remove existing supply, if installed, by pulling label cartridge from printer.
6. Insert new cartridge until spindle ends rest in slots of holder [5].
7. Feed labels from top of roll until it sits just past the black rubber roller.
8. Close supply guides until they touch edge of supply liner with labels under the guides.
9. Move supply wiper into position so it rests on the label.
Note: Not all labels require the use of the supply wiper. Engage the wiper only if needed for the
labels installed.
3
5
4
10. Close and latch print head door, then close enclosure cover.
11. If printer was asleep, press . The system detects the installed supplies, sets background
and foreground colors, indicates the label dimensions and the amount of remaining supplies.
BradyPrinter S3000
9