Makita HS7010 Instruction Manual page 8

6
3
4
2
► 1. Hex wrench 2. Shaft lock 3. Hex bolt 4. Outer
flange 5. Loosen 6. Tighten
2. Remove the hex bolt and outer flange.
3.
Turn the lever to open the blade guard.
1
► 1. Lever
4. Remove the blade.
► 1. Hex bolt 2. Outer flange 3. Circular saw blade
4. Inner flange
1
5
1
2
3
4
8 ENGLISH
To install the circular saw blade, follow the removal
procedure in reverse.
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place saw
blade, outer flange and hex bolt.
1 2
► 1. Mounting shaft 2. Inner flange 3. Circular saw
blade 4. Outer flange 5. Hex bolt
WARNING:
BE SURE TO TIGHTEN THE HEX
BOLT CLOCKWISE SECURELY. Also be careful
not to tighten the bolt forcibly. Slipping your hand
from the hex wrench can cause a personal injury.
Blade guard cleaning
When changing the circular saw blade, make sure to
also clean the upper and lower blade guards of accu-
mulated sawdust as discussed in the Maintenance
section. Such efforts do not replace the need to check
lower guard operation before each use.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
► 1. Hex wrench
5
4
3