Table of Contents
Advertisement
You can locate a misplaced handset by paging it.
1.
Base unit: [
]
All register handsets beep for 1 minute.
2.
To stop paging:
Base Unit: Press [
Handset: Press [
Transferring calls
Outside calls can be transferred or a conference call with an outside party can be made between 2 handsets.
1.
During outside call, press [
2.
Select the handset you want to page by pressing the desired handset number ([1] –[4]) or you can page all handset by
pressing [
]
3.
Press [
]
4.
The call will transfer to the paged handset
Changing the Battery___________________________________
Changing the Battery
CAUTION: To reduce the risk of fire or personal injury, use only the CCT Tech USA Inc.
approved model SL-422943 Li-polymer battery (Ni-MH), which is compatible with this unit.
1. Make sure the telephone is OFF (not in TALK mode) before you replace the battery.
2. Remove the battery compartment door.
3. Disconnect the cord attached to the battery pack and remove the battery pack from the handset.
4. Insert the new battery pack and connect the cord to the jack inside the battery compartment.
5. Put the battery compartment door back on.
6. Place handset in the base or handset charge cradle to charge. Allow the handset battery to properly charge (for 16
hours) prior to first use or when you install a new battery pack. If you do not properly charge the phone, battery
performance will be compromised.
NOTE: The RBRC seal on the battery used in your CCT Tech USA Inc. product indicates that we are participating
in a program to collect and recycle the rechargeable battery (or batteries). For more information go to the RBRC
web site at www.rbrc.org or call 1-800-8-BATTERY or contact a local recycling center.
Battery Safety Precautions_______________________________
• Do not burn, disassemble, mutilate, or puncture. Like other batteries of this type, toxic materials could be released which
can cause injury.
• To reduce the risk of fire or personal injury, use only the Li-ploymer battery listed in the User's Guide.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
Troubleshooting Guide__________________________________
Telephone General Use
Problem
The handset does not turn on even after installing
battery pack.
The unit does not work.
]
]
]
Cause/solution
- Place the handset on the base unit or charger to
turn on the handset
- Make sure the battery pack is installed correctly.
- Fully charge the battery.
Check the connections. (for 16 hours)
- Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
- The handset has not been registered to the base
unit. Register the handset.
Advertisement
Table of Contents
