AEG IR Radio S Operation And Installation page 9

Instructions for radio operation/
16
Mounting of the wall bracket
N O T E !
The short-wave infrared radiant heater is operated by the IR Radio
S/IR Radio W remote control via the IR Radio Dimmer 2000.
The short-wave infrared radiant heater can only be switched off
completely by unplugging the mains plug on the IR Premium or
IR Comfort.
N O T E !
Before installation in the required assembly position, check that
the transmitter and receiver are functioning properly.
The bracket has to be fixed so that the drill hole does not touch
any electrical lines.
85
7,5
Mounting of the wall bracket
Use the drilling template on the inside of the packing box.
1. Remove the cover from the box.
2. Cut out the template for the wall bracket.
3. Fix the drilling template to the wall.
4. Drill the holes in the wall
5. Remove the drilling template.
6. Attach the bracket to the wall with the two wall plugs and screws which are
provided.
Explanation of functions/
programming the transmitter
Transmission control light
A radio signal is displayed by the lighting up of the transmission control light.
The transmission control lamp flashes when transmitting if the battery power is
reduced.
The transmitting power or the radio range will be reduced through the reduction
in the performance of the battery. If the transmission control light no longer
lights up when a button is pressed, the batteries have to be replaced.
Programming the transmitter
!
P R E R E Q U I S I T E !
The IR Radio Dimmer 2000 must be installed.
1. Disconnect the fuse - and reconnect after a few seconds.
You now have 5 minutes of time in which to start the programming mode.
2. Position yourself in front of the radiant heater with the IR Radio S/IR Radio W.
3. Press the programming
button P with a pin
(on the back of the
device).
4. Press the v button
immediately when 100%
heat output appears.
5. Press the b button
immediately when 50%
heat output appears.
You have now programmed the IR Radio S / IR Radio W.
17
The radiant heater switches
between 100% and 50% of its
heating power for 2 minutes.
Heating switches off for a
short time
Heating switches off