AEG IR Radio S Operation And Installation page 11

Technical data/changing the battery/cleaning
20
Technical data
Operating voltage
Battery type
IP Code
Permitted ambient temperature
Radio frequency
Notification number
Dimensions in mm (manual transmitter)
Dimensions in mm (wall bracket)
Battery replacement
N O T E !
• Replace batteries only with batteries of the identical type
(CR 2032).
• Dispose of used batteries properly (collection point).
1. Undo the screw on the back of the IR Radio
S/IR Radio W.
2. Open the housing.
3. Remove the battery.
4. Place the new batteries (CR 2032) into the
transmitter in the correct position.
5. Close the housing.
6. Tighten the screw on the back of the device.
Cleaning
Clean the device with a damp cloth only.
Do not use cleaning agents, these can attack the plastic.
3 V DC
1 x CR 2032
IP 20
0 to +55 °C
868.3 MHz
CE 0682
L 74 x W 44 x H 15
L 85 x W 85 x H 18
Disposal/notes on repair/Notes on troubleshooting
Disposal
Please observe the current national regulations.
Dispose of according to the condition and existing regulations.
e.g. as:
• Electronic waste (PCB)
• Plastic (Housing parts)
• Batteries
Notes on repair
Please contact us if you are unable to eliminate a problem.
When contacting our service team, please always state the item description and
number from the type plate (back of device).
– Item number
– Item description
– Type of fault
Notes on troubleshooting
Fault Cause
No radio reception Transmitter is not
programmed.
Heater does 1. Radiant heater
not heat. wrongly connected.
2. Heating element
is defective.
– Accompanying conditions
– Own presumption
– Previously occurring unusual events
Remedy
Program the transmitter.
1. Check connection.
2. Replace heating
element.
21