AEG IR Radio S Operation And Installation page 10

Programming additional transmitters
18
Programming additional transmitters/channels
N O T E !
If several receivers are connected to the same feed line, then all
are simultaneously ready to program.
Programming possible for max. 16 transmitters.
The radiant heater begins to briefly light up 'at random' .
The longer you wait with the programming the greater will be
the offset.
Individual channels/transmitters can now be assigned to the
respective receiver.
You can stop the flashing if you briefly push the STOP button of
a transmitter which has already been programmed.
The channel assignment/change can now be made without you
having to disconnect the individual receivers.
To programme additional transmitters in one receiver, please proceed as follows:
Press the following buttons on
the programmed transmitter
simultaneously:
v-button
b-button
Programming button P
(Back of unit)
Press the v button immediately when
100% heat output appears.
(New transmitter)
Press thee b button immediately when
50% heat output appears.
(New transmitter)
The transmitter is now programmed.
The radiant heater
switches between 100%
and and 50% of its heating
power for 2 minutes.
Heating switches off for
a short time
Heating switches off
Switching the radiant heater on/off
Switching on the intermediate stage/deleting a transmitter
Switching on the radiant heater
!
P R E R E Q U I S I T E !
The transmitter is now programmed.
Press the v or b button.
Switching off the heating system.
Press the STOP button.
N O T E !
The IR Radio Dimmer 2000 automatically switches the connected
radiant heater(s) off after 12 hours.
Switching on intermediate stages
!
P R E R E Q U I S I T E !
The transmitter is now programmed.
1. Briefly press the v button twice in succession.
The radiant heater heats with approx. 75% of its rated power.
2. Briefly press the b button twice in succession.
The radiant heater heats with approx. 50% of its rated power.
Deleting individual transmitters
1. Press simultaneously:
• Programming button P (on back of device)
• STOPP button
2. Hold down this button combination until the LED goes out briefly 3 times.
Deleting all transmitters
1. Press simultaneously:
• Programming button P (on back of device)
• v Button
• STOPP button
• b Button
2. Hold down this button combination until the LED goes out briefly 3 times.
19