Advertisement
Enroll the RF6PIR
The RF6PIR can be enrolled and
programmed before or after installation.
• Press down on the top latch and separate
the front and back covers.
• Set the Lyric Smart Controller in
Programming Mode.
• Remove the RF6PIR battery tab to
activate and begin the enrollment process.
• The green LED beneath the battery flashes
during enrollment (about 8 seconds) and
the control beeps (TBD).
• The device sends the device MAC ID
address and Services information to the
control. The control registers the device
and displays the transmitter data on
screen.
• Enrollment is confirmed when the RF6PIR
LED is ON for 3 seconds
beeps TBD].
• If the sensor is not successfully enrolled
during the enrollment period, the LED
turns off and the device powers down.
Activate a tamper to restart the enrollment
process.
Programming RF6PIR Services
Fault device features to "Learn" device
"Services" in the control:
- Cover and Wall tamper switches
- Selectable Pet Immunity –
Off or up to 80 lbs (36 kg)
- Temperature sensor; accuracy ±3°F
Consult the Lyric Smart Controller's
instructions for programming the device in
the system.
Walk Test the RF6PIR
After power up and enrollment, activate the
Test Mode with the control (see control's
instructions) or use the Flashlight Feature.
Test period.
Note: the system must be in disarmed mode for
the 10 minute Test mode to begin.
Walk through the detection area and observe
the LED.
Test Mode is active for 10 minutes, then
automatically exits test mode, disables the
LED and enters normal operation mode.
To restart the 10 minute Test Mode, use the
flashlight feature (see the following section).
[and the control
Note: Once enrolled in a system, the sensor
cannot be used with another control panel until
it is removed from the current control panel. See
the Control's instructions for details on
removing devices.
Advertisement
