Toshiba MMD- AP0091BH Installation Manual page 15

Cable connection
• Be sure to pass the wire through the wire connection port of the indoor unit.
• Keep a margin (Approx. 100mm) on a wire to hang down the electric parts box at servicing, etc.
• The low-voltage circuit is provided for the remote controller.
• Remove the cover of the electric parts box by taking off the mounting screws (2 positions) and pushing the
hooking section. (The cover of the electric parts box remains hanged to the hinge.)
• Tighten the screws of the terminal block, and fix the wires with cord clamp attached to the electric parts box.
(Do not apply tension to the connecting section of the terminal block.)
• Be sure to set a loop for the connecting wire of the storing
part of the indoor unit electric parts; otherwise the electric
parts box cannot be drawn out in service time.
• Mount the cover of the electric parts box without
pinching wires.
R(L) S(N)
U1 U1 A B
Inter-unit cable
Cable cramp
between indoor
and outdoor units
Remote controller wire
REQUIREMENT
Power supply cable
15
Electric
parts box
R S
(L) (N)
Connecting wire hole
Electric parts box cover
Earth line
Connecting
cable