Usb Connection; Bluetooth Connection - Honeywell IH21 Quick Start Manual

USB Connection

The ePop-Loq USB connection on the IH21 can be configured in
one of two modes – Charge-Only or Charge-and-Data. Please
ensure the mode required is correctly configured.
• Charge-Only mode: Both the IH21 UHF Reader and the
mounted device will be charged when docked in the charging
cradle, but will never use the USB data connection.
• Charge-and-Data mode: Compatible devices will use the USB
data connection when not in the charging cradle. Note that
USB data connection to the IH21 requires a custom
application that supports the TSL ® ASCII protocol over USB.

Bluetooth Connection

The IH21 Bluetooth Handheld UHF RFID Reader is compatible
with many Bluetooth wireless technology enabled host devices
including Android and Xamarin.
The Bluetooth version is BT4.2 and supports both Bluetooth Low
Energy and Bluetooth Classic.
To pair with a Bluetooth host device
Squeeze the Trigger Button to wake up the IH21 UHF Reader
and wait for the blue LED to start flashing (if it does not flash,
please check the battery is charged and properly installed).
In your host device's 'Bluetooth
pair with the IH21 UHF Reader. In the list of Bluetooth
the IH21 UHF Reader will be identified by its serial number
(xxxxxx-IH21). (Make sure the Reader has not 'timed-out' and
gone to sleep, as it will not be discoverable).
Settings' page, search for and
®
devices,
®