List Of Menus - Sony MSB-2000 Operation Manual

List of Menus

List of Menus
The menu items are in the following categories.
A:proc (process)
B:mode
C: setup (tx-rx, tx-rx (cm), sdi_to_asi, asi_to_sdi,
sdti-cp_to_asi, asi_to_sdti-cp)
E:link_mng
L:network
M:setup-msb
N:maintenance
P:save
R:recall
S:osd
T:status
U:log
In the following tables, the factory default settings are
enclosed in boxes.
The following symbols are also used.
*: Not supported by Versions 1.01 to 1.30.
**: Available when the MSBA-20IP is installed.
A:proc (process) menu
This is used as a setting value execution command.
Item number Category
A proc
B:mode menu
This is used as a operating mode selection command.
Item number Category
B mode
Item Function
start Checks the consistency of setting values, and if there is no problem
carries out the setting change.
If there is an inconsistency, returns the command number of the
related setting.
analyse Checks the consistency of setting values, and if there is no problem
returns OK.
If there is an inconsistency, returns the command number of the
related setting.
Item Function
tx-rx Bidirectional encoder/decoder mode (sdi_to_asi/asi_to_sdi)
tx-rx (cm) Bidirectional endoder/decoder mode, communication mode
sdi_to_asi SDI input encoder mode
asi_to_sdi SDI output decoder mode
sdti-cp_to_asi SDTI-CP input encoder mode
asi_to_sdti-cp SDTI-CP output decoder mode
Menu items not included in the categories
listed at left
help (RS232C/telnet)
info (RS232C/telnet)
remote1 "stop" "play" "rec" "ff" "rew" "cueup
{hhmmssff}"
"standby_on" "standby_off"
"status" "tc"
remote2 "stop" "play" "rec" "ff" "rew" "cueup
{hhmmssff}"
"standby_on" "standby_off"
"status" "tc"
snmp*** "init" "sys" "host" "comm" "trap"
For details of the snmp menu, see the section "SNMP
Commands" (page 90).
36