Page 1
122 122XL anual Copper Cutting and Prep Machines 99 Washington Street Melrose, MA 02176 Phone 781-665-1400 Toll Free 1-800-517-8431 Visit us at www.TestEquipmentDepot.com...
122/122XL Copper Cutting and Prep Machines Safety Symbols In this operator’s manual and on the product, safety symbols and signal words are used to communicate important safe- ty information. This section is provided to improve understanding of these signal words and symbols.
122/122XL Copper Cutting and Prep Machines moving parts. Damaged or entangled cords increase Power Tool Use and Care the risk of electric shock. • Do not force power tool. Use the correct power tool for your application. The correct power tool will do the •...
Standard Equipment • Only use the machines to cut, clean and deburr The 122 and 122XL Copper Cutting and Prep Machines copper or stainless steel tubing as directed in come with the following items: this manual.
Page 5
Holder Motor-Driven Motor-Driven Rollers Rollers Figure 1B – 122 Copper Cutting and Prep Machine Figure 2B – 122XL Copper Cutting and Prep Machine Rack and Pinion The machine serial number is located on the rear side of Adjustable Warning Label Handle the machine.
122/122XL Copper Cutting and Prep Machines Icons O. D. Deburring Disk (optional accessory for the 122) Power ON 1. Hold the O.D. brush shaft stationary by gripping the flats located near the surface of the housing with a " Power OFF wrench (Figure 5).
122/122XL Copper Cutting and Prep Machines 8. After the inspection is complete, move the ON/OFF Clean dirt and debris from the rollers. Rollers must be switch into the OFF (O) position and, with dry hands, kept clean to insure proper machine performance.
122/122XL Copper Cutting and Prep Machines Using Foot Switch (120V only) For ease of operation, the 122 and 122XL can be used with Model 301A Foot Switch–120. 1. With dry hands plug the 301A Foot Switch into a properly grounded outlet or extension cord.
Page 9
122/122XL Copper Cutting and Prep Machines • Keep hands and fingers away from reamer, wire brushes and ends of the tubing. This operating position will help to maintain control of tubing and the machine. Cutting Tubes 1. Check that the tubing is not visibly bent and no fittings are attached.
Page 10
122/122XL Copper Cutting and Prep Machines 9. When tubing stops rotating, remove from the machine. 3. Place the tubing over the reamer cone and gently Raise the cutter handle. apply pressure (Figure 13). Do not force the tube into the reamer. This will remove burrs from inside of Cleaning/Deburring O.D.
122/122XL Copper Cutting and Prep Machines 2. Remove cutter wheel screw and replace the cutter Maintenance Instructions wheel (Figure 15). See Accessories section for avail- WARNING able cutter wheels. Make sure that the ON/OFF switch is in the OFF 3. Reinstall the roller and slide assembly and securely position and the machine is unplugged before per- tighten the shoulder bolt.
Any problems not sories specifically designed and recommended for addressed by this section should only be handled by an use with the 122 and 122XL Copper Cutting and authorized RIDGID service technician. Prep Machines such as those listed below. Other...
122/122XL Copper Cutting and Prep Machines Disposal Parts of the 122 and 122XL Copper Cutting and Prep Machines contain valuable materials and can be recycled. There are companies that specialize in recycling that may be found locally. Dispose of the com ponents in com- pliance with all applicable regulations.