Operating Online Operation Screen - Mitsubishi MELSEC-Q Series User Manual

9
UTILITY OPERATION

9.2.6 Operating Online operation screen

POINT
(1) Online operation screen
Module information Event history
Item
Read parameter
button
Read
Write parameter
button
Write
"It clears all parameters
before writing" check box
1. If a communication error has occurred during connection, make the
connection target setting again.
2. Communication are not available during reset of the C Controller module.
Start communication after terminating the reset process.
This screen allows parameter read/write/verification, remote operation, clock setting,
and IP address setting for the C Controller module.
Table9.15 Explanation of Online operation screen
SRAM monitor Module monitor
Reads parameters from the C Controller module.
Writes parameters, which were set on the C Controller setting utility, to the
C Controller module.
The written parameters become valid when the C Controller module is
powered off and then on or is reset.
This button can be used only when "Write authority" was checked at the
time of connection target setting (
This button cannot be used without "Write authority". (
*1
9.1.3).
Clicking the above
Write
parameters (including the CC-Link module parameters, MELSECNET/H
module parameters, and intelligent function module parameters) before
the parameters are written.
Figure 9.33 Online operation screen
Online operation
Description
Section 9.1.3).
button with this check box checked clears all
9.2 C Controller Setting Utility
9.2.6 Operating Online operation screen
Reference
section
Section
(To next page)
9
- 35
9
10
11
12
13
14
15
16