Mitsubishi MELSEC-Q Series User Manual page 167

5
SETTINGS AND PROCEDURES BEFORE OPERATION
Name
1) Indicator LEDs
10BASE-T/100BASE-TX interface
2)
connector (RJ45)
3) RS-232 interface connector
4)
RUN/STOP/MODE switch
*2
5)
RESET/SELECT switch
6) EJECT button
CompactFlash card installation
7)
slot
8) Battery
9) Battery connector pin
Table5.2 Part names
Refer to this section (1) for the indicator LEDs.
Connector used to connect the C Controller module to 10BASE-T/100BASE-TX.
(The C Controller module determines 10BASE-T or 100BASE-TX depending on
the target device.)
Connector used to connect the C Controller module to RS-232.
*2
Refer to this section (2) for the RUN/STOP/MODE switch.
Refer to this section (3) for the RESET/SELECT switch.
Used to remove the CompactFlash card from the C Controller module.
Slot used for installing the CompactFlash card into the C Controller module.
(A dummy CompactFlash card is factory-installed.
Used for protecting the standard ROM files, and backing up the battery-backed-up
RAM data and the clock data.
For connection of the battery lead wire.
(The lead wire is shipped disconnected from the connector to prevent battery
consumption.)
* 1 Keep the dummy CompactFlash card in a safe place after replacing it with an actual
CompactFlash card so that it can be used again in the future when the CompactFlash card is
removed.
* 2 Operate the RUN/STOP/MODE switch and RESET/SELECT switch by hand.
Using a screwdriver or any other tool can cause a failure.
Description
*1
)
5.4 Parts Names and Functions
1
2
3
4
5
6
7
8
5
- 19